INSTALLATION OF THE FRONT GRILLE
Depending upon the location
of the AC outlet, route the AC
cord to either the left or right
side while installing the front
grille.
This figure shows the AC cord
routed to the left side.
Place the front grille on
1
the cabinet first.
Secure the front grille to
2
the main chassis using
screw provided.
INSERT THE
(OPTIONAL)
Attach the
(part no.
CZ-SF6P) to the frame.
The
and the frame can be obtained separately
from your nearest servicenter.
INSERT THE AIR FILTER
Attach the air filter to the intake grille.
PLACE FRONT INTAKE GRILLE OVER THE FRONT GRILLE
Slide the front intake grille slightly to the right to reattach the
tabs and then push it down to close tight.
Slot in the
and the
frame (part no. CZ-SFW6P) to
the front grille.
Lift up about 90°.
REMOVAL OF FRONT GRILLE
Remove the front intake grille.
1
Pull up the front intake
grille about 90° and slide
it slightly to the left to
unhook the tabs.
Remove the air filter.
2
Tilt up and pull out the air filter
by the holder.
Air filter
Remove the front grille.
3
a a a a a
Remove the adhesive tape from
b b b b b
all sides of the front grille.
At bottom right side of the front
grille, press inward on cabinet
near the power cord, and pull
the grille outward to the right
c c c c c
until right tab releases.
At the bottom left side, push
inward on cabinet and pull the
grille outward to the left to
release the left tab. Do not pull
the bottom edge toward you more than 3 inches to prevent the two
d d d d d
top tabs from damage.
Slide the front grille upwards to free the two top tabs from slots
at the top of the cabinet.
HOW TO ATTACH THE DRAIN PAN (OPTIONAL)
Condensed water drainage
This air conditioner employs a
"Slinger-Up System" which is
designed to splash the condensed
water on the condenser coil for
maximum cooling efficiency, thus
producing a splashing sound.
If the splashing sound annoys you,
you can provide an outside drainage
by using the following procedure
which may, however, cause a small
loss of performance.
NOTE
The cabinet should be installed tilted
slightly lower to the rear for
necessary condensate drainage.
(Max. 13/32")
b b b b b
a a a a a
c c c c c
d d d d d
Maximum
13/32"
Condensed water