Publicidad
Idiomas disponibles
Idiomas disponibles
A. If installing appliance on the floor level,
you must maintain the minimum distance
of 14" to combustibles (see Figure 8).
Figure 8 - Minimum Fireplace Clearances
If Installed at Floor Level
This appliance is factory
preset for propane/LP gas.
No changes are required for
connecting to propane/LP.
Only a qualified installer or service
technician can perform gas selec-
tion and connecting to gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited.
CAUTION: To avoid gas leak-
age for the gas not being used at
the inlet of regulator, a qualified
installer or service technician
must use supplied plug.
WARNING: Do not attempt to
access or change the setting of
the fuel selection means.
1. The inlet regulator is color coded for iden-
tification of the correct gas type. Blue is for
propane (LP gas) and yellow is for natural
gas.
2. The inlet regulator requires a 3/8" NPT
threaded fitting. Apply a thread sealant
that is rated for use with the type of gas
that is being used.
12
INSTALLATION
FLOOR CLEARANCES
Combustible
Material
14"
Min.
Noncombustible Material
GAS SELECTION
www.usaprocom.com
B. If combustible materials are less than 14"
to the fireplace, you must install appliance
at least 5" above the combustible flooring
(see Figure 9).
Figure 9 - Minimum Fireplace Clearances
Above Combustible Flooring
3. Determine the type of gas that will be
used by the appliance. If your gas type is
Propane/LP remove the blue dust cover.
If your gas type is Natural gas remove
metal plug from natural gas inlet. Remove
blue dust cover from propane/LP inlet and
install metal plug. This will keep debris out
of regulator.
Access Regulator from Back of Log Set
Insert Gas Fitting
for Propane/LP Gas
Blue Propane/LP Gas
Plunger Underneath
Dust Cover
Figure 10 - Gas Regulator
Hearth
Combustible
Material
5"
Min.
Insert Gas Fitting
for Natural Gas
Yellow Natural Gas
Plunger Underneath
Metal Plug
200133-01A
Publicidad
