Maintenance; Technical Data - Foy DE310A Manual De Usuario Y Garantía

4. Do not overload the trimmer, cut small sec-
tions to improve cutting efficiency, keep it run-
ning at high speed. (Fig. 3)
5. Use the edge of the guard as a guide when
cutting close to fences or walls, etc. Moving
back toward edger prevent damage.
TAP&GO SYSTEM
SEMI-AUTOMATIC FEEDING SYSTEM
This electric trimmer is equiped with a Tap&Go
system located on the head.
RENEWAL OF NYLON
To renew the nylon
the engine must be
running at full speed,
tap the head against
the ground and the
nylon line will auto-
matically be released
(Fig. 4), the blade will cut the excess line and
leave it to the right length.
REPLACING THE LINE
1. Firmly press the
release buttons on
the cover of the reel
(Fig.5a).
2. Remove the reel
cover (Fig.5b), remove
the reel and the old
nylon line.
3. Attach the nylon on the reel (arrow in Fig. 6)
and wrap it carefully.
4. Follow the same procedure in step 3 to place
the nylon on the opposite side.
Fig. 6
NOTE: Wrap both sides and let out enough
nylon to easily slip them into the holes on the
reel (Fig. 7).
5. Place reel with the renovated nylon in the
head and at the same time accommodate the
nylon lines on the nylon feed holes.
6. Place the reel lid in the head, apply pressure
Fig. 3
and make sure it is securely positioned in place.
connect the trimmer from the power supply,
keep your feet or other objects that may trig-
ger the switch when cleaning inside the guard
or manually feed nylon.
1. Disconnect the trimmer from the power
source.
2. Never clean your trimmer with water, clean-
ing fluids or solvents, remove the waste with
the appropriate tool, soft brush or dry cloth.
3. Using a brush, clean inside the security guard
Fig. 4
and clean the grass or any residue.
4. Using a soft brush, clean inside the security
guard, the blade, the motor housing.
5. Inspect and look trimmer parts misaligned.
6. If the trimmer is damaged, contact a service
center atorizado.
aged.
7. Store in a clean, fresh out of reach of children.
can be repaired by the user, take it to an au-
thorized service center, the disregard of these
b
Fig. 5
instructions could void your warranty.
a
VOLTAGE-FREQUENCY
SPEED
CUTTING CAPACITY
NYLON DIAMETER
POWER
WEIGHT
Fig. 7
E N G L I S H •

MAINTENANCE

CAUTION: Avoid accidental starting. Dis-
IMPORTANT: Never use a brushcutter dam-
ATTENTION: This trimmer has no parts that

TECHNICAL DATA

U se r 's m a nu a l
120 V ~ 60 Hz
10 000 r/min
10" (254 mm)
1,2 mm
300 W
2,5 kg (5,5 lb)
11