Publicidad
Idiomas disponibles
Idiomas disponibles
Setup
Battery Installation
1. On the back of the remote, push down on the tab
and lift the cover off.
2. Match the batteries to the + and - marks inside the
battery case, then insert 2 AAA Alkaline batteries.
3. Press the battery cover back into place.
Battery Saver
Your remote automatically turns off if the buttons are
depressed more than 30 seconds.
Code Saver
You will have up to 10 minutes to change the batteries
in your remote without losing codes you have
programmed. However, do not press any buttons until
batteries are installed in the remote. If buttons are
pressed without batteries in the remote, all codes will be
lost.
Direct Code Entry
NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a TV code under the CBL
button, or a TV code under the SAT button, etc.
However, you can only store TV codes under the TV
button.
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired mode button (TV,
SAT/CBL). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator flashes.
4. With your device on, press CHANNEL UP. If the
device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your
brand.
6
Setup, cont.
Write your codes down here for easy reference later.
Type
Type stored
TV
SAT/CBL
Code Search
If your product does not respond after you have tried all
the codes for your brand, or if your brand is not listed,
try searching for your code by following these steps.
1. Manually turn on the device (TV, SAT, CBL) to be
controlled.
2. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
3. Press and quickly release the desired mode button
(TV, SAT/CBL). The red indicator blinks off once.
4. Press the CHANNEL UP button repeatedly (up to
300 times) until the device to be controlled changes
channel. The red indicator blinks off with each
button press. If you accidentally overshoot the
code required, press the CHANNEL DOWN button
to backtrack through the library until the device
changes channel. Pressing CHANNEL UP changes
direction to forward again.
5. Press and release MUTE to install the code.
Most users will store satellite or cable codes under the
SAT/CBL button. If (for example) you want to store a TV
code under SAT/CBL, first follow the procedure for
Direct Code Entry (previous page) and press SAT/CBL
in step 2 of Direct Code Entry, then enter ANY TV code
in step 3 of Direct Code Entry. Then follow the steps
above for Code Search (or Brand Search, below).
Note: Code Search starts from the currently stored 4
digit number under that mode.
Code
7
Publicidad
