All manuals and user guides at all-guides.com
ENGLISH
USING YOUR MARGARATOR – A QUICK START GUIDE
(Continued)
While unit is still on, place glass or a container under spigot and dispense the chosen drink
by pushing the spigot up. It is recommended to have a towel under the spigot to protect
against any drips.
NOTE: the spigot has a locking upright position for filling multiple drink glasses or a pitcher
of drinks.
8
If spigot drips after dispensing, place glass or container under spigot and open and
close
the valve by pushing down and "snapping" the spigot once or twice quickly.
Small ice chips can sometimes get caught in the gasket
preventing it from closing completely.
9.
Turn off the unit when desired consistency is achieved and it will
keep the Margarita mix cold.
10. ALWAYS DISPENSE WITH MARGARATOR RUNNING. Allow
the unit to run for a good 8 seconds to mix before dispensing if
unit has been sitting.
NOTE: WHEN HANDLE IS LOWERED OR LID IS REMOVED
WHILE THE MACHINE IS RUNNING, THE MOTOR WILL STOP
RUNNING UNTIL LID AND HANDLE ARE PROPERLY REPLACED
TROUBLESHOOTING
PROBLEM
Power not turning on
Mix is not dispensing
CLEANING THE UNIT
1.
Unplug the unit from the electrical outlet.
2.
Dispense all remaining lliquid from the unit through the spigot.
3.
Unlock top (See Illustration A) from base and rinse with clean water by pouring into
tank and dispensing thoroughly through the spigot until clear. Wipe inside and out
with a clean non-abrasive cloth or sponge. Dry with soft non-abrasive clean cloth.
4.
Wipe the bottom base with a wet non-abrasive cloth and towel dry again using a
soft clean non-abrasive cloth to avoid scratching the surface.
Easily store your MARGARATOR ™ for the next event!
By following these simple instructions, your MARGARATOR™ will be fun for friends, family,
and kids of all ages...by creating delicious servings of your favorite beverages and making
anytime an event.
NOTE: To prolong the life of your MARGARATOR™, be sure to follow the cleaning
instructions after every use and make sure the spout is flushed while washing the unit to prevent
build up.
4
F
POSSIBLE CAUSE/REMEDY
Check the plug; make sure it is properly plugged
into outlet.
Make sure lid and handle are locked and handle is
aligned properly
Make sure the blending cage did not loosen and
float up.
Make sure the unit still has liquid inside
Make sure the spigot area did not freeze
Make sure unit is in the ON position.