Publicidad
Idiomas disponibles
Idiomas disponibles
Controls
Features and appearance will vary.
8
Power
On/Off
Auto
High
Med
Low
Fan
NOTE:
when setting the set temperature.
Air Conditioner Controls
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
2. Display
Shows the room temperature. Shows the Set
temperature while setting the temperature in Cool or
Energy Saver modes. The Set light will turn on while
setting.
3.
mode. The Set light will turn on while setting.
4. Fan Speed Pads
on the unit. NOTE: On the remote control, use the fan
speed Increase + / Decrease – pads to set the fan
speeds to Low, Med or High
Auto fan on.
5. Mode Pad
Fan Only mode.
6. WiFI Connect
Enables connection of the air conditioner to the home
WiFi. Download App for details at www.GEAppliances.
com/connect.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
the signal receiver on the air conditioner.
the remote control that could block the signal.
up to 20 feet.
4
Light indicates the unit is in
the temperature set mode.
+
Set
-
Cool
Fan Only
Energy Saver
Reset
WiFi
Mode
Filter
Connect
Low, Med, High or Auto
Auto pad to turn
Cool, Energy Saver or
Light indicates
WiFi connection
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
7. Reset Filter
LED will turn on when fan has accumulated 250 hours of
run time as a reminder to clean filter. Press Reset Filter
to turn off the LED and reset the accumulated run time.
NOTE: The default temperature reading on the display
is degree Fahrenheit ( °F). To change the display to
degree Celsius (°C), press the Temp Increase
Temp Decrease
seconds. Repeat the process to change back to degree
Fahrenheit (°F)
8. Control Display On and Off
To reduce brightness during sleeping hours, this air
conditioner control display has an automatic off feature
where the control display will turn off completely after 5
minute of inactivity. To illuminate the control interface,
press any button on the control display or remote
control. The control display will illuminate all previously
illuminated LED's. The control interface will now respond
to any prescribed button press after it is illuminated.
Press and hold the FAN button to toggle this feature ON
or OFF. The LED's will now stay ON anytime the unit is
ON.
indicated on the remote control.
metal surfaces.
Fan
Fan
Remote Control
buttons together and hold for 3
Auto Fan on
Fan speed
Increase
on/off
and
49-7804-1
Publicidad
