Descargar Imprimir esta página

Kenwood X1200M Manual De Instrucciones página 4

Amplificador de potencia clase d monofónico

Publicidad

Idiomas disponibles

Idiomas disponibles

Connection
WARNING
Remove the ignition key and
disconnect the negative · terminal of
the battery to prevent short circuits.
CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or connectors
are touching the car body. Do not remove
caps from unconnected wires or connectors to
prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
* Commercially available parts
WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery's positive terminal.
About the Lead Terminals
1. Wire Thicknesses
You can use wires with the following thicknesses:
Battery wire and ground wire
Speaker wire
2. Strip the wire
Make a cut in the wire sheath (insulator made from vinyl, etc.) at the
position 10-13 mm away from the end of the wire, and then remove the
unnecessary portion of the sheath by twisting it.
3. Install the wire
Loosen the screw using the supplied hexagon wrench. Insert the
conductor of the wire in the terminal hole, and then tighten the screw.

English
Hexagon Wrench
(Small)
Hexagon
Wrench
(Large)
Use the attached
Hexagon Wrench.
Protective Fuse*
Battery wire*
Ground wire*
Battery
AWG 4 – AWG 6
AWG 8 – AWG 12
CENTER UNIT
(CD receiver, etc.)
Power control wire*
BATT.
GND
FUSE [30Ax3]
P.CON
SPEAKER OUTPUT
Terminal cover
Dual voice coil subwoofer
SPEAKER OUTPUT
Hexagon
Wrench
10 - 13 mm
(Large)
(3/8" - 1/2")
RCA cable*
L
REMOTE
R
LINE IN
LINE OUT
Hexagon Wrench
(Small)
Use the
attached
Hexagon
Wrench.
Subwoofer (L + R)
(≥2Ω)
When two subwoofers are
connected. (≥4Ω)
(4Ω + 4Ω)
SPEAKER OUTPUT
Hexagon Wrench
(Small)
Left input
Right input
(2Ω + 2Ω)

Publicidad

loading