Publicidad
Idiomas disponibles
Idiomas disponibles
OWNER'S MANUAL
100% of Ram Capacity
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to
potential personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the kit in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust,
or any other harmful elements. The kit must be cleaned of water, snow, sand, grit, oil, grease or other foreign matter before using.
2. Based on continuous engagement and disengagement of the hose from the cylinder, eventually it will become necessary to add hydrau-
lic fluid to the pump's reservoir. Completely retract the ram before adding hydraulic fluid. Do not overfill in order to avoid personal injury
and hydraulic malfunction. Use only hydraulic jack oil,
fluids will cause damage to the hydraulic seals.
IMPORTANT: In order to prevent seal damage and kit failure, never use alcohol, hydraulic brake fluid or transmission oil in the pump.
3. Every kit owner is responsible for keeping the kit labels clean and readable. Use a mild soap solution to wash external surfaces
of the kit components but not any moving hydraulic components.
4. Do not attempt to make any hydraulic repairs unless you are a qualified hydraulic repair person that is familiar with this equipment.
Repairs must be performed by an authorized service center.
TROUBLESHOOTING
PROBLEM: RAM WILL NOT LIFT RATED LOAD
Turn reservoir fill screw (P7) counterclockwise two complete revolutions and wait 10 seconds. Turn screw clockwise
ACTION:
until tight and proceed to pump. If that does not fix the problem check the pump reservoir's fluid level. The proper amount of
fluid should be 22 ounces. Use only hydraulic jack oil. For any other problems contact Sunex hydraulic service center.
OWNER/USER RESPONSIBILITY
BEFORE USING THIS KIT, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the kit owner to make sure all personnel read this manual prior to using the kit. It is also the responsibility of the kit
owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible,
contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed
with the operator in the operator's native language by the purchaser/owner or his designee, making sure the operator comprehends its
contents.
4910B
APPLICABLE FORCE
FOR COMPONENT SET UPS
100% of Plunger Toe Capacity
Spreader Capacity
100% of Ram Capacity
100% of Rubber Head Capacity
12% of Ram Capacity
50% of Plunger Toe Capacity
25% of Ram Capacity
25% of Ram Capacity
6% of Ram Capacity
Chevron Hydraulic Oil AW ISO 32 or its equivalent Unocal Unax AW 150
4
MODEL 4910B
CAPACITY: 10 TON
PORTABLE RAM KIT
. Other
04/13/21
Publicidad
