Publicidad
Idiomas disponibles
Idiomas disponibles
PEDESTAL INSTALLATION
For dryer
For washer/combo
3
Place the dryer on the pedestal. Make sure
the front and back feet are in the correct
positions. The dryer feet will fit into the
innermost positions as shown.
Raise
Loosen the locknuts on all 4 leveling feet of
5
the pedestal until you can turn them with
the wrench. Turn the leveling feet clockwise
to raise or counterclockwise to lower until
the pedestal is level and all 4 feet are solidly
against the floor.
40
All manuals and user guides at all-guides.com
(cont.)
Lower
Make sure the screws on the pedestal align
4
with the holes in the retainers, then install 4
screws on each side to securely attach the
appliance to the pedestal.
NOTE: If the screws are not installed
properly, noise and vibration may result.
Push the dryer into position.
Securely tighten all locknuts by wrench.
6
NOTE: Noise and vibration may result if
locknuts are not tightened.
Be sure to connect the appliances to all
water, power, or gas lines and draining or
venting connections before operation.
If there is excessive vibration during the
first operation after installation, slightly
adjust the leveling feet.
Locknut
Publicidad
