Clatronic KA 3473 Instrucciones De Servicio página 29

Instructions
Placement
•
Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot tip
over.
•
Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
Electric Connection
NOTE:
Make sure the device is switched off. The switch must be
at the "0" position.
1.
the type label.
2. Connect the mains cable to a properly installed and earthed
wall outlet.
Operation
moves dust, which may have collected during transport. Follow
the instructions given under "Operation".
Operation
1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups of
coffee into the rear water tank. The water level is displayed
on the indicator.
NOTE:
CAUTION:
3.
4.
5. Now close the lid of the water tank.
6. Place the jug onto the warming plate.
CAUTIION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in the
•
Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
•
If there is still water in the tank, place the pot under-
7. Switch on the device. The indicator lamp in the switch will
light up.
The Coffee Is Ready
NOTE:
The brewing process lasts approximately. 10-15 minutes.
•
remove the pot.
•
Turn the device off.
NOTE:
-
for example.
WARNING:
If you want to make another pot of coffee immediately, switch
-
De-scaling is necessary when the brewing time increases
substantially.
•
Use only commercially available citrus acidbased de-scaler.
•
Follow the recommended instructions for use.
WARNING:
•
Afterwards you should boil fresh water in the pot three or
four times in order to rinse out residues of the descaling
agent.
•
Do not use any coffee powder!
•
Do not use this water for consumption.
WARNING:
•
Before cleaning, always remove the mains plug and wait
until the device has cooled down.
•
Do not immerse the device in water. Otherwise this might
CAUTIION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
•
The exterior of the device should be cleaned as necessary
with a slightly damp cloth – without any additives.
•
Remove spilled coffee grounds with a paper towel from the
inner casing. Afterwards wipe with a damp cloth.
•
ing in warm water. Use a soft brush if necessary.
De-scaling
Cleaning
-
29