Publicidad
Idiomas disponibles
Idiomas disponibles
3. Switching cooling / heating mode
Press the cool / heat switch button to switch the oper-
ating mode.
The temperature display flashes the control
temperature.
•
When the appliance operates in cooling mode, the
control temperature is -10 °C, -5 °C, 0 °C, 5 °C or
10 °C (15 °F, 25 °F, 30 °F, 40 °F or 50 °F).
•
When the appliance operates in heating mode, the
control temperature is 55 °C or 60 °C (130 °F or
140 °F).
4. Selecting the control temperature
Press the temperature plus button or the temperature
reduction button to select the control temperature.
The appliance starts cooling / heating 5 seconds after
without any operation, then the control temperature stop
flashing and the temperature display shows the current
temperature.
The appliance stops cooling / heating when the current
temperature reaches the control temperature.
Tips for efficient cooling
Opening the upper cover for long periods can cause
significant increase of the temperature in the chamber.
•
Clean regularly surfaces that can come in contact
with food and accessible drainage systems.
•
Store raw meat and fish in suitable containers in
the chamber, so that it is not in contact with or drip
onto other food.
•
If the chamber is left empty for long periods:
-
Switch off the appliance.
-
Defrost the chamber.
-
Clean and dry the chamber.
-
Leave the upper cover open to prevent
mould developing within the chamber.
FUNCTION
Indicating the remaining battery
capacity
The battery indicator shows the remaining battery
capacity.
The remaining battery capacity is shown as the follow-
ing table.
Battery indicator status
On
Remaining
battery
capacity
Off
50% to 100%
20% to 50%
Battery indicator status
On
(Blinking)
(Only for battery cartridges with the
indicator)
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.3
► 1. Indicator lamps 2. Check button
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Appliance / battery protection system
The appliance is equipped with the protection system.
This system automatically cuts off power to extend
appliance and battery life. The appliance will automati-
cally stop during operation if the appliance or battery is
placed under one of the following conditions.
1. Battery overdischarge protection
When the battery capacity becomes low, the
appliance stops automatically. The battery indi-
cator prompts that the battery should be charged.
Remove the batteries from the appliance and
charge the batteries.
10 ENGLISH
Off
Off
Blinking
malfunctioned.
Remaining
battery
capacity
0% to 20%
Charge the
battery
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
Publicidad
