Publicidad
Idiomas disponibles
Idiomas disponibles
• Make sure the lid is closed tightly before you start a load of laundry.
Delay End
You can set the washer to finish your wash automatically at a later time by choosing a
delay of between 1 to 24 hours (in 1 hour increments). The hour displayed indicates the
time the wash will finish.
1. Select a cycle. Then, change the cycle settings if necessary.
2. Press Delay End repeatedly until a desired end time is set.
3. Press and hold Start/Pause (Hold to Start) .
4. To cancel Delay End , restart the washer by pressing Power .
Real-life case
You want to finish a two-hour cycle 3 hours from now. To do this, you add the Delay End
option to the current cycle with a 3-hour setting, and then press and hold Start/Pause
(Hold to Start) at 2:00 pm. The washer starts operating at 3:00 pm and ends at 5:00 pm.
Provided below is the time line for this example.
2:00 pm
Set Delay End to 3 hours
Alarm Off
You can turn the alarm sound on or off. When the alarm is off, the cycle completion
melody and the power-off beep will not sound. However, button and alert sounds will
remain on.
• To mute the alarm sound, press and hold Super Speed for 3 seconds.
• To unmute the alarm sound, press and hold again for 3 seconds.
• Your setting will be kept even after you turn off and then restart the machine.
Pre Soak
Press and hold Deep Fill for 3 seconds to add 18 minutes of soaking time at the start of
the wash cycle for better stain removal.
Untitled-3 49
Untitled-3 49
3:00 pm
Start
5:00 pm
End
English 49
2021-07-14
2021-07-14
12:20:14
12:20:14
Publicidad
