Publicidad
Idiomas disponibles
Idiomas disponibles
1. Drill in the gate 2 holes of 10.2 mm each to a distance of 68 mm one
from each other.
2. Fix the bracket in the holes.
3. Fix the motor piston to the front bracket using screws (these are not
included as they vary depending on the thickness of the gate).
4. Insert the locking nut and the washers.
Brackets installation height
Make sure that the height of installation of the rear bracket is equal to the
height of installation of the front bracket. Performing an assembly based on
inaccurate measurements can lead to problems in the operation of the piston
arm. Also, the opening and closing force will be reduced. Large differences
in height between the two brackets can even burn the motor and the piston
arm.
User manual
10
Publicidad
