Atlantic 73812 Manual Del Producto página 2

Introduction
Thank you for selecting an Atlantic Fountain Basin Plumbing Kit. Before using the Kit please
take a moment to review this manual.
The FBKIT1 Plumbing Kit is intended for use with the FB2400, FB3200 and FB4600
Fountain Basins when installing one decorative item. The FBKIT3 is intended for use with
FB3200* and FB4600 when installing multiple decorative items.
FBKIT1 INSTALLATION INSTRUCTIONS
Step 1:
Install the pump. The diagram to the right shows the proper
installation of the discharge fittings and
valve when used with the FB3200 Fountain
Basin and TidalWave Pumps. Discharge
fittings and tubing are included for connection
of Tidalwave FP-Series and MD-Series Pumps.
Tubing must be cut to length on site based on
the requirement of the installation.
Step 2:
Next, install the 3/ 4 " insert fittings into both ends
of the ball valve. Connect one end of the tubing
to the outlet of the ball valve. Loop the tubing
into the second plumbing channel and cut it to
the desired length. Insert the barbed end of the
¾" elbow into the open end of the tubing.
Step 3:
Place the decorative item such as a vase, column,
or cored boulder on the fountain basin and
position directly over the ¾" elbow. Run the ¾"
PVC standpipe (not included) through the
decorative item and into the socket end of the ¾"
elbow. Seal the opening around the standpipe
with the supplied SPSEAL Standpipe Sealant.
Standpipe Sealant is an EPDM based product
that will remain pliable and can be reused. With
heavier items such as cored boulders it may be
easier to set the standpipe into the elbow first
before installing the standpipe into the boulder.
2
1 1/2" Ball
3/ 4 " Insert x
Valve
1/2" MPT
3/ 4 " Kink-free Tubing
3/ 4 " Insert x
1/2" MPT
MD250 - 750
FP200 - 500
(not included)
3/ 4 " KINK FREE
TUBING
3/ 4 " PVC
STANDPIPE
(not included)
STANDPIPE
SEALANT
3/ 4 " INSERT X 3/ 4 "
SOC 90˚