Dometic RTX2000 Instrucciones De Instalación página 13

CoolAir RTX1000, RTX2000
6.4 Preparing the unit
A
NOTICE!
When preparing the unit on the work surface, make sure it is secured
against falling off.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
Proceed as follows (fig. 7):
➤ Place the parking cooler on a work surface with the casing facing
down.
➤ Screw the 12 self-tapping M8 threaded plugs into the blind holes
marked "1" and "4".
To do so, use the 1/4" bit supplied.
6.5 Attaching the seal for the cab roof
A
NOTICE!
Ensure that the surface where the seal between the unit and the cab
roof is to be glued is clean (free of dust, oil, etc.).
➤ Glue the sealing strip to the cab roof (fig. 8 A).
Follow the contour of the roof hatch opening. The join between the
ends of the seal should be at the back.
– lveco Stralis Hi-Street/Hi-Road: Sealing strip size 10 x 20 mm
– lveco Stralis Hi-Way: Sealing strip size 35 x 20 mm
➤ Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710)
to the join between the ends of the sealing strip and to the top edge of
the sealing strip (fig. 8 B).
EN
Installation
11