Publicidad
Idiomas disponibles
Idiomas disponibles
Start and Programs
Programs
Program
Sensor
Drying
(heavy loads)
Sensor
Drying
(light loads)
Timed Drying
up to 120 minutes
Fabric Care
Air Fluff Phase
Fabric Care
Easy Iron
Easy Iron Program
Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute Air Fluff period) which fluffs the
fibers of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes
the fibers and makes them easier to iron and fold.
! Easy Iron is not a drying program and should not be used for wet articles of clothing.
For best results:
1. Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric
Regular Cotton and Regular Cotton mix
Permanent Press
Denim
2. Unload the dryer immediately after the end of the program, hang, fold or iron the articles and put them away.
Should this not be possible, repeat the program.
The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Regular Cottons
or Regular Cotton mix, and less well on acrylic fibers.
service@aristonamerica.com
Get user manuals:
See SafeManuals.com
What it does...
Dries completely: your
clothes are ready to be worn.
For heavy loads (from 7 to
13 lb / 3 to 6 kg) of Regular
Cottons.
Dries completely: your clothes
are ready to be worn.
For light loads (from 2 to 7 lb /
1 to 3 kg) of Regular Cottons,
Permanent Press.
Dries wet clothing that will be
ironed, acrylic fibers, or small
loads (less than 2 lb / 1 kg).
Heating elements turn
themselves off and clothing is
cooled down.
Brief program (approximately
10 minutes) that softens fibers
of clothing that is ready for
ironing.
How to set it...
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMS knob
on
.
3. Press the START button.
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMS knob
on
.
3. Press the START button.
1. Select required heat setting HIGH
HEAT or LOW HEAT by pressing
the HEAT button.
2. Position the PROGRAMS knob on
the desired time.
3. Press the START button.
This is the final phase of all programs.
Approximately 10 minutes before the
finish, the knob advances
automatically to the Air Fluff phase.
After this the clothing is ready to be
taken out.
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMS knob on
.
3. Press the START button.
Maximum load
5.5 lb / 2.5 kg
4 lb / 2 kg
4 lb / 2 kg
Note:
! If you select LOW HEAT, this
program will not dry your
clothes. For Acrylic fibers or
small loads select Timed
Drying.
This programme can also be
used for light loads if you prefer
a damper result.
! If you select LOW HEAT, this
programme will not dry your
clothes. For Acrylic fibers or
small loads select Timed
Drying.
This program can also be used
for heavy loads if you require a
slightly drier result.
Consult suggested drying
times (see Laundry).
Always allow the dryer to
complete this phase.
!
This is not a drying
program (see below).
EN
5
Publicidad
