Jonsered LM2146M Li58-52 Manual De Usuario página 11

in operation. The cutting mode button then stops
flashing.
Note: If the motor control handle is released during
operation, the product stays in the current cutting mode.
If the product automatically stops, or the operator
presses the power button, the cutting mode used before
is erased from memory and the product starts in Auto
mode when started again.
Battery status indication during
operation
The display on the user control interface shows the
battery capacity and if there are problems with the
battery pack. The battery capacity is shown while the
machine is in operation.
LED lights Battery status
All Green Fully Charged (100% - 76%)
LEDs come on
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
General recommendations for
maintenance
The warranty on this product does not include incorrect
or not careful operation of the product by the operator.
To receive full value from the warranty, the operator
must do maintenance on the product as written in the
instructions of this manual. Different adjustments must
be made at different intervals to keep your product in
correct work condition.
• Examine the blade for wear each year.
To examine the tires
• Keep the tires free of unwanted material and
chemicals to prevent damage to the rubber.
• Keep the tires away from stumps, stones, ruts, sharp
objects and other objects which can cause damage
to the tires.
To do a general inspection
• Check that nuts and screws are tight.
• Make sure no cables are pinched.
Maintenance schedule
Use the maintenance schedule to see the necessary
maintenance requirements of your product, and when
the maintenance must occur. The intervals are
calculated on average use of the product and may be
different because of how frequently you use it.
853 - 002 - 18.10.2018
LED lights
LED 1, 2 and 3
come on
LED 1 and 2
come on
LED 1 comes
on
LED 1 flashes
If there is an error with the battery pack during
operation, all four green LEDs of the battery state of
charge display flash. Remove the battery pack from the
machine and press the indicator button on the battery
pack to show the error code for the error. The LED's on
the battery pack illuminate and show an error code if an
error has occurred. Consult the battery manual for a list
of error codes and solutions to the errors.
MAINTENANCE
• Tighten bolts and nuts before each use and before
storage.
• Examine the tires before each use.
• Clean the product after each use and before storage.
Use a scraper to clean below the deck.
• Examine the blade for damage and cracks in 25 hour
intervals. Replace blades more frequently if you cut
in sandy soil.
• Lubricate the product in 25 hour intervals.
• Clean and fully charge the battery pack after use and
after storage. Charge the battery pack for max. 24
hours before storage.
• Do not keep the battery pack on the battery charger
during storage. Charge the battery pack for a
maximum of 24 hours.
• Examine the drive belt and pulleys in 25 hour
intervals (if equipped).
To clean the product
• Use a brush to remove unwanted material and grass
on the product.
• Keep unwanted material off finished surfaces and
wheels.
• Use a scraper below the product to remove the
buildup of grass and waste.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the electrical
powerhead or battery contacts.
• When you clean below the product, remove the
battery pack and put the product on its side with the
user control interface pointing up.
Battery status
The battery pack is 75% - 51% charg-
ed.
The battery pack is 50% - 26% charg-
ed.
The battery pack is 25% - 6% charg-
ed.
The battery pack is 5% - 0% charged.
11