Publicidad
Idiomas disponibles
Idiomas disponibles
installing your dryer
If the new dryer is installed into an existing exhaust system you must make
sure:
•
The exhaust system meets all local, state, and national codes.
•
That a flexible plastic duct is not used.
•
To Inspect and clean all lint buildup from inside the existing duct.
•
The duct is not kinked or crushed.
•
The exhaust hood damper opens and closes freely.
The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be
less than 0.
This can be measured with the dryer running with a manometer at the point where the exhaust
duct connects to the dryer. A no-heat setting should be used. The dryer tumbler should be
empty and the lint filter clean.
10_ installing your dryer
DV330AE-02820A-09_EN.indd Sec5:10
DV330AE-02820A-09_EN.indd Sec5:10
2012-10-11
2012-10-11
5:43:22
5:43:22
Publicidad
