Publicidad
Idiomas disponibles
Idiomas disponibles
3
Installation
3.1. Right place for installation
Contact the Authorized Service for
the product's installation. To ready
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If not, call an electrician
and plumber to arrange the utilities as
necessary.
WARNING:
B
assumes no responsibility for
any damage caused by the work
carried out by unauthorized
persons.
WARNING:
B
cable must be unplugged during
installation. Failure to do so may
result in death or serious injuries!
WARNING:
is too narrow for the product to
A
pass, remove the door and turn
the product sideways; if this does
not work, contact the authorized
service.
•
Place the product on a flat surface to
avoid vibration.
•
Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to
direct sunlight or keep in damp
environments.
•
The product requires adequate air
circulation to function efficiently.
The manufacturer
The product's power
If the door span
8 /24 EN
•
If the product will be placed in an
alcove, remember to leave at least 5
cm distance between the product and
the ceiling and the walls.
•
Do not install the product in
environments with temperatures
below -5°C.
3.2. Attaching the plastic wedges
Use the plastic wedges in the provided
with the product to provide sufficient
space for air circulation between the
product and the wall.
1. To attach the wedges, remove
the screws on the product and use the
screws provided with the wedges.
2. Attach 2 plastic wedges on the
ventilation cover as shown in the figure.
Refrigerator / User Guide
Publicidad
