Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Read all the sections of this booklet and follow all the instructions carefully.
Using for the First Time
WARNING:
Never plug in the control
panel when it is not installed in the fryer
body with heating element in the oil
container. Do not immerse the control
panel, cord or plug in water.
WARNING:
This unit should not be
used to boil water.
Prior to First Use, Clean the Unit
Thoroughly
WARNING:
Always let the fryer cool
completely for 2 hours before taking it
apart for cleaning. Never carry or move
the deep fryer with hot oil inside. Before
cleaning, always make sure the plug is
not in the wall socket.
•
All components with the exception of
the electrical parts, can be washed in
warm soap water. Dry thoroughly
before use.
•
Use basket handle to remove the frying
basket. Always make sure the basket
handle is securely attached to the
basket. Attach the handle to the frying
basket, insert the metal part of the
handle inside the metal bracket on the
frying basket. (Fig. 1)
Fig. 1
•
Lift the control panel with heating
element out of its slots by pushing it up
from the bottom with one hand while
holding the body of the deep fryer with
your the other hand.
•
Remove the oil container.
•
Clean the oil container and the frying
basket with hot water, dishwashing
liquid or other non-poisonous detergent
and non-abrasive sponge.
WARNING:
Never immerse the control
panel in water or any other liquids.
WARNING:
All components must
be completely dried before filling
with oil or using. Special care must
be taken to ensure the washable oil
filter in the lid is completely dry,
otherwise the filter will not function
properly and may lead to steam
being trapped within the fryer during
use.
WARNING:
Never exceed "MAX"
line when filling the basket with food.
Filling the Oil Container
WARNING:
Never plug in the deep
fryer before filling with oil to specified
level. Always make sure control panel
is securely in place in the body and the
heating element is inside the oil in the
container before plugging in.
•
Use blended vegetable oil, pure corn
oil or canola (rapeseed) oil. Do not use
olive oil, margarine, lard or drippings.
•
The oil level must always be
maintained between the minimum and
the maximum levels marked inside the
oil container. Check the oil level before
each use. For best results, Do NOT
exceed "MAX" level for cooking oil.
(Fig.2)
•
Never mix different oils and fats
together. Do not mix old and new oil.
3
Using Solid Fat
WARNING:
Do not put solid shortening
in the oil container or the frying basket.
•
If using solid vegetable shortening,
melt it first in a separate pan and then
very carefully pour the melted fat into
the oil container.
•
Previously used solid vegetable
shortening which has curdled and
hardened in the oil container should be
removed from the oil container and
melted in a separate pan before
reusing.
WARNING:
If you try to melt the
solidified fat in the oil container, there is a
risk of warm melted fat suddenly
sputtering from below through the still
solid top layer of fat.
Therefore use only the following
procedure:
•
Make sure the fat is at room
temperature. If the fat is very cold,
there is a greater risk of splashing.
•
Using a fork, carefully make some
holes in the fat. Make sure the lid is
securely closed while fat is melting.
Press the "Function" Reset button
and press timer button to set the time
you require.
Installing the "Control Panel with
the Heating Element" into its Place
•
Lift up the control panel with heating
element.
•
Insert the "guide edges" on the control
panel into the "guide rails" mounted
on the metal body. (Fig. 3)
•
Slide the "guide edges" down till the
end.
Guide Rails
Fig. 3
Fig. 2
Back of Main Body
OPERATING INSTRUCTIONS
Important Notice:
safety switch ensures that the unit will not
operate unless the control panel has been
inserted into the "guide rails" on the metal
body correctly. (Fig. 4)
Control Panel
Guide
Edges
Safety Switch
Using the Electronic Deep Fryer
WARNING:
Never plug in the deep fryer
before filling with oil to specified level.
Always make sure control panel is securely
in place in the body and the heating
element is inside the oil in the container
before plugging in.
Important:
Ensure the control panel is
fitted correctly to the main unit otherwise
the unit will not function. This is not a
defect. This product is fitted with a safety
switch to prevent the unit from turning on
accidentally.
4
The automatic
Fig. 4
Heating Element
Publicidad
