Publicidad
Idiomas disponibles
Idiomas disponibles
Untitled-18 25
1. Attach the water hoses to the hot and cold water
taps, and then hand tighten the water hose fittings
until they are tight. Then, use pliers to tighten the
fittings by an additional two-thirds of a turn. To avoid
damaging the fittings, do not overtighten them.
2. Pull the water hoses to check if they are firmly
connected.
3. Put the other ends of the hoses into a bucket, and
then open the water taps for 10 - 15 seconds to
remove impurities. When done, close the taps.
4. Attach the water hoses to the hot and cold water
inlets on the back of the washer, and then hand
tighten the water hose fittings until they are
tight. Then, use pliers to tighten the fittings by an
additional two-thirds of a turn.
NOTE
If you do not want to use the hot water supply hose,
attach the water intake cap to the hot water supply
intake. When you do a wash, press Temp. to select Cold.
English 25
2022-12-22
3:48:44
Publicidad
