Ryobi RY124050 Manual Del Operador página 14

WARNING:
To avoid serious personal injury, always remove the
battery pack from the product before inspecting, cleaning
or performing any maintenance.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Never use water or any liquids to clean or rinse off your
product and do not expose the product to rain. Store
indoors in a dry area. Corrosive liquids, water, and chemi-
cals can enter the product's electronic components and/
or battery compartment and damage electronic com-
ponents and/or the battery pack, which can result in a
short circuit, increased risk of fire, and serious personal
injury. Remove any buildup of dirt and debris by wiping
the product clean with a dry cloth occasionally.
WARNING:
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed accord-
ing to local ordinances and bylaws.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or de-
stroy plastic which could result in serious personal injury.
PUMP LUBRICATION
The pump on this unit is lubricated with a sufficient amount
of high grade lubricant for the life of the unit under normal
operating conditions. Therefore, no further lubrication is
required.
STORING THE POWER CLEANER
Store in a dry, covered area where the weather can't damage it.
It is important to store this product in a frost-free area. Always
empty water from all hoses, and the pump, before storing.
Remove the battery and store in a secure location out of

the reach of children.
Disconnect all hoses. Before removing the battery, press

the switch to allow all water to drain from the power
cleaner.
Neatly coil the siphon hose and store with power cleaner.

Press the button on the power cleaner and pull to remove

the spray wand. Store the unassembled spray wand and
nozzle with the cleaner.
Store the unit and accessories in an area that does not

reach freezing temperatures. Do not store near furnace or
other sources of heat that could dry out the pump seals.
12 — English