MHTeam EH2 Serie Manual De Instrucciones página 4

3. Instructions for Use
Before switching the heater on, position the heater so that it stands upright on a firm
surface and at a safe distance from wet environments and flammable objects.
Start
Set the thermostat knob (2) to the MAX position. Turn the power selector switch (4) to the
desired level. As the desired room temperature is reached, turn the thermostat knob (2)
back and stop it when you hear a click. The thermostat will cycle the heat elements on and
off to maintain a constant room temperature. Please note that the fan will run
continuously.
Note: when you switch the heater on for the first time, some smell may be released from
the heating elements: this is a normal effect that will cease in a few hours.
Shutdown
Turn the power selector switch (4) to Fan position and the thermostat knob (2) to MIN
position, let the appliance cool down for 2 minutes, then turn the power selector (4) to 0
and unplug the heater.
Please note that EH2-05 has an extra thermostat to control the fan: if temperature of
heaters is too high this device start the fan to cool the heater down despite than the
power switch is on 0 position.
Do not cover the heater. Do not block the air inlet and outlet.
The heater outlet is very hot during operation and after use. Do not touch!
Children should be supervised to ensure that they do not play with the appliance.
The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
Unplug the heater before moving it. Never pull the cable to unplug or move the unit.
Do not leave the heater unattended when in use.
Do not use the heater with a programmer, timer or any other device that can switch the
heater on automatically.
Never use the appliance with wet hands or when either the heater or the power cable is
wet.
If the supply cable is damaged, it must be replaced by the manufacturer, by a service
agent or a similar qualified person.
The heater is equipped with a safety thermostat that protects it from overheating. In case
of overheating, the safety thermostat will shut the heating elements off and allow the fan to
rotate to cool the unit. Check for possible causes of overheating: blocked inlet or outlet,
blocked fan, low fan speed, excessive room temperature, etc. and eliminate them. Should the
problem repeat, shut down the heater and contact technical service.
4. Cleaning, Maintenance and Storage
Regularly wipe the body using a soft sponge or cloth. For very dirty parts, use a sponge
wetted with lukewarm water and a mild detergent, then dry using a clean cloth.