Publicidad
Idiomas disponibles
Idiomas disponibles
In order to maximize the cleaning efficiency, be sure to clean the filter cone before and
after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base. Make sure the pool
vacuum is OFF
Emptying filter cone
1.
Place the pool vacuum on a stable surface.
2.
Turn the locking knob (on each side) anticlockwise until it is pointing towards the
green marking to unlock and release the transparent canister. Remove the
transparent canister from the rear body.
3.
Tilt the transparent canister and make sure the smaller end is pointing upwards,
then pull out the filter cone from the transparent canister. Hold the filter cone
horizontally and turn its lid clockwise to detach it from the cone.
4.
Rinse the transparent canister and clean out the debris inside the filter cone. It is
recommended to clean the filter cone's net with splashing water. If brushing is
deemed necessary, use only a soft brush to clean it carefully and gently. DO NOT
apply any pressure to the net.
5.
To lock the lid onto the filter cone, align the slot of the lid's edge to the tab of the
bottom part of the cone. Push the lid on the cone and turn the lid anticlockwise
until it stops. Attach the filter cone to the transparent canister.
CAUTION! Replace a damaged filter cone immediately with a new one before the
next operation.
9/175
Publicidad
