BWT BC30 Manual De Usuario página 9

2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the water draining valve. Water is
going to escape via the handle / pole connector and draining holes inside the handle
chamber on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool. Otherwise, the pole connector may be bent and damage the pool vacuum
in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING!
Using the pool vacuum without a filter cage in place will
VOID your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cage before and
after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base. Make sure the pool
vacuum is OFF
 Emptying the filter cage
1. Place the pool vacuum on a stable surface.
Press the locking button until the locking hole on the clear canister is released. Slide
2.
the canister away until the notch on the bottom of canister opening is released from
the hook on the bottom of main body. Remove the filter cage from the main body.
CAUTION! Replace the damaged filter cage immediately before the next operation.
3. Clean out the debris and rinse the filter cage with water. If brushing is deemed
necessary, use only a soft brush to clean the filter cage gently and carefully.
4. Re-position the filter cage inside the main body. Make sure the filter cage is
completely inserted inside the main body.
Inverkehrbringer: BWT Pool Products GmbH, Rödgener Straße 8-9, 06780 Zörbig 8/155