Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Attaching the track to the header board:
1. Place the track in the center of the header board and determine where you want it to be
installed.
NOTICE
2. Mark locations for all 5 holes.
3. Using the 5 marks you made, drill a 1/4" (6 mm) pilot hole 1" - 3" (25 - 76 mm) deep on each
mark.
4. Follow steps 2 through 6 under "Attaching the track directly to the studs".
Installing door stops
1. Slide one door stop (C1, C2) on each end of the tack, making sure the hex screws are facing
up and the actual stops are facing the door.
2. Determine where you want the door to stop in both directions, then move the door stop to that
location and tighten down the hex screws with the hex wrench.
Step 4: Installing Hangers and Anti-Jump Disc
8
Make sure the track is level before making your hole marks.
Ø7/16" (11 mm)
Ø7/16" (11 mm)
Publicidad
