Cleaning And Storage - weasy WH500 Manual De Usuario

Make sure that there are no large, pointy objects on the area to be cleaned.
■
Do not in any case vacuum up the following:
■
– smouldering ashes, cigarette butts, matches etc.,
– flammable or ignitable materials,
– very fi ne dust (e.g. cement dust), ash or toner,
– pointy, hard objects such as larger glass shards,
– liquids and wet dirt.
Empty and clean the dust bin after every use (see chapter "Cleaning and
■
storage").
Do not use the device when it is connected to the mains adapter.
■
1. Stick the nozzle adapter on the suction opening.
2. If desired, attach the extension tube to the nozzle adapter.
3. Attach the desired nozzle to the extension tube.
The nozzles can also be attached to the nozzle adapter directly without attaching
the extension tube between them.
4. Switch the device on. This can be done in one of two ways:
– By gently holding the On / Off switch down. The device will switch off when you
let it go.
– By firmly pushing the On / Off switch once and then releasing it. If you would like
to switch the device back off, push the On / Off switch again
5. The device will immediately start to vacuum clean.
6. Run the device over the area to be cleaned.
7. Turn the device off.
8. If you would like to remove the nozzles, simply pull them off the nozzle adapter
or off of the extension tubes.
IV. Cleaning and storage
Ensure that the device has been deactivated before
■
you clean it!
Never immerse the device, the mains adapter, the
■
rechargeable battery or the cable in water or other liquids.
The device may not be connected with the mains
■
adapter when cleaning the dust bin.
Never use soap or other cleaners to clean the dust and
■
HEPA fi lter. Otherwise this would damage the filters.
The filters are not suitable for the washing machine,
■
dishwasher or dryer! Only air