Publicidad
The outside dimensions shall be: 20.00" (50.8 cm) tall x 12.69" (32.2cm) wide x 11.06" (28.1 cm) deep, and
the weight shall be 28 lbs (12.7 kg). Power requirements shall be: 110 Watts nominal, 100-120 VAC, 50/60 Hz
™
Domestic and 220-240 VAC, 50/60 Hz (Export). The loudspeaker system shall be called a Peavey PVXp
10 .
GENERAL SPECIFICATIONS
Frequency Range, 1 Meter On-Axis, Swept-Sine In ½ Space Environment: 52 Hz to 20 kHz
Frequency Response, 1 Meter On-Axis, Swept-Sine In Anechoic Environment: 65 Hz to 20 kHz (+/- 3 dB))
Usable Low Frequency Limit (-10 Db Point Anechoic): 54 Hz
Nominal Sensitivity (1w @1m, Swept Sine Input In Anechoic Environment): 96 dB (average)
Maximum Sound Pressure Level (1 Meter): 122 dB SPL peak with music
Radiation Angle Measured At -6 Db Point Of Polar Response: Nominal: 100 degrees horizontal X 60 degrees
vertical (Axis of the vertical main polar lobe is angled down 10 degrees, resulting in the angular pattern with
respect to straight ahead being +20, -40 degrees)
Transducer Complement: Heavy-duty 10" woofer with 2-3/8" voice coil & 50 oz. magnet, RX
10N 1" titanium
™
diaphragm dynamic compression driver with Neo magnet
Box Tuning Frequency: 75 Hz
Electroacoustic Crossover Frequency: 3,100 Hz
Crossover Type: Internal Electronic two-way crossover with driver EQ, level matching, bass boost and subsonic
filtering.
Crossover Slopes: 24 dB/octave (4th order) low pass, 24dB/octave (fourth order) high pass, both with
staggered poles and driver EQ.
Input Connections: One combo female XLR /1/4" phone jack providing balanced line-level operation from the
1/4" jack section, and high-output dynamic microphone operation from the XLR section.
Output Connections: One male XLR and one 1/4" phone jack. he Thru jacks are intended for the use of linking
multiple PVXp 10 's in a line or to provide a feed to a powered subwoofer, or other electronics that needs to
receive a full range version of the input signal.
Enclosure Materials & Finish: Black ABS plastic with textured surface, black powder-coated perforated grille.
Also available in white.
Mounting Provisions: Unit has two sets of two widely spaced M8 inserts, one pair on the top, and one pair on
the bottom.
Additional mounting points are a set of four M8 inserts on the top and a set of four on the bottom, which use
the Peavey VersaMount 70+ mounting bracket.
Four rubber feet provide vibration free floor or stage use, and a molded-in stand mounting cup is on the bottom.
Dimensions (H x W x D):
20.00" x 12.69" x 11.06" 508 mm x 322 mm x 281 mm
28 Lbs. (12.7 kg))
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Internal Power Amplifiers (@120 VAC line):
Total of 400 watts peak available power
Woofer - 300 watts peak available power
Continuous Power: 150 watts @ less than 1% distortion
Tweeter - 100 watts peak available power
Continuous Power: 50 watts @ less than 1% distortion.
Publicidad
