Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Installation and use
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running unattended.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
INSTALLATION:
- The device must be placed on a non-flammable, water-repellent and stable surface.
- If it is placed near another element (wall, furniture, equipment, etc.), ensure that it is
non-flammable and water repellent.
- Leave a space of at least 5 to 10 centimeters between each element and the appliance.
MANUAL :
WARNING
Before first use in production, run the appliance empty in its normal operating conditions for 10 minutes
(temperature 60 ° C minimum) then wait for it to cool and clean it.
- Put water in the tank provided for this purpose.
- Electrically connect the device.
- Switch on the device by pressing the switch.
- Set the thermostat to the desired temperature.
At the end of the use of the device:
- Set the thermostat to minimum.
- Switch off the device by pressing the switch.
- Electrically disconnect the device.
- Wait until the appliance has cooled completely before cleaning it.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
EN
Publicidad
