Publicidad
Idiomas disponibles
Idiomas disponibles
Testing (Walk Test)
After installation, press the test button, walk in the scope by
crossing the infrared spectrum (see below diagram), and watch the
LED indicator to make sure it is working. The LED indicator will flash
once when body movement is detected.
Connect with the Control Panel
When the control panel is in connecting state, press the test button
on the detector twice to send wireless signal. One beep is heard
after panel receives signal, which means of successful connection.
Arm the system, trigger the detector again. The panel will alarm
immediately. This indicates the detector has been successfully
connected with the panel.
Note:
Make sure other detectors are not triggered while connecting.
High detection sensitivity
Low detection sensitivity
EN
Publicidad
