Publicidad
Idiomas disponibles
Idiomas disponibles
English
nOTE: The chuck accepts 1/4" (6.35 mm) hex accessories
and 1" (25.4 mm) bit tips or above.
Place the forward/reverse button
(center) position or remove battery pack before
changing accessories.
To install an accessory, fully insert the accessory into the
quick-release chuck
4
. The accessory is locked into place.
To remove an accessory, pull the chuck collar
from the front of the tool. Remove the accessory from the
quick-release chuck
4
.
Fig. B
Fig. C
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
6
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
5
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
8
2
in the lock-off
3
away
3
3
into the tool handle, align the
Fig. D
5
Proper Hand Position (Fig. E)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
8
.
Fig. E
Usage
CAUTION: Ensure fastener and/or system will
withstand the level of torque generated by the tool.
Excessive torque may cause breakage and possible
personal injury.
1. Place the accessory on the fastener head. Keep the tool
pointed straight at the fastener.
2. Press switch to start operation. Release switch to stop
operation. Always check torque with a torque wrench,
as the fastening torque is affected by many factors
including the following:
Voltage: Low voltage, due to a nearly discharged
-
battery, will reduce fastening torque.
Accessory size: Failure to use the correct accessory
-
size will cause a reduction in fastening torque.
-
Bolt size: Larger bolt diameters generally require
higher fastening torque. Fastening torque
6
8
Publicidad
