Publicidad
Idiomas disponibles
Idiomas disponibles
Wire Brush Operations
Wire brushes are intended to "clean"
structural steel, castings, sheet metal, stone
and concrete. They are used to remove rust,
scale and paint.
especially when working corners, sharp
edges etc. This can cause loss of control
and kick-back.
FIG. 21
WIRE CUP BRUSH
CORRECT:
Wire tips
doing
the work.
INCORRECT:
Excessive
pressure can
cause wire
breakage.
Operating Instructions
Avoid bouncing and
snagging the wire brush,
Brushing Pressure
1.Remember, the tips of a wire brush do
the work. Operate the brush with the
lightest pressure so only the tips of the
wire come in contact with the work.
2.If heavier pressures are used, the wires
will be overstressed, resulting in a wiping
action; and if this is continued, the life of
the brush will be shortened due to wire
fatigue.
3.Apply the brush to the work in such a way
that as much of the brush face as possible
is in full contact with the work. Applying
the side or edge of the brush to the work
will result in wire breakage and shortened
brush life.
WIRE WHEEL BRUSH
CORRECT:
Wire tips
doing
the work.
INCORRECT:
Excessive
pressure can
cause wire
breakage.
-23-
Publicidad
