Publicidad
Idiomas disponibles
Idiomas disponibles
C.
2
Copper Tubing
Connect valve body to water supplies using
the proper fittings for your valve body type
(copper tubing, iron pipe or Pex). Note: (1) is
the cold inlet port and (2) is the hot inlet
port. If either of the two outlet ports is to be
unused, seal the port with a pipe plug.
D.
1
Remove bonnet (1). Warning: Avoid
soldering at high temperatures.
107529 Rev. F
2
1
1
Iron Pipe
If you are making a back to back or
reverse installation (hot on right and
cold on left) install the valve body as
described, but the water supply lines will
be reversed. Note: (1) is the hot inlet
port and (2) is the cold inlet port.
Be sure stops (2) are removed from the
w/stops version before soldering. (Do not
install stops before soldering.)
4
2
1
Pex
2
Publicidad
