Ryobi TC4011 Manual Del Operador página 6

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product . Please study them and learn their meaning. Proper in-
terpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Safety Alert
Read Operator's Manual
Eye Protection
Wet Conditions Alert
No Hands Symbol
Electrocution
V Volts
A Amperes
Hz Hertz
W Watt
min Minutes
Alternating Current
n o
No Load Speed
Class II Construction
.../min Per Minute
SYMBOLS
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand opera-
tor's manual before using this product.
Always wear eye protection with side shields marked to comply
with ANSI Z87.1.
Do not expose to rain or use in damp locations.
Failure to keep your hands away from the cutting wheel will result
in serious personal injury.
Failure to properly ground can result in electrocution.
Voltage
Current
Frequency (cycles per second)
Power
Time
Type of current
Rotational speed, at no load
Double-insulated construction
Revolutions, strokes, surface speed, orbits etc., per minute
6 — English
DESIGNATION/EXPLANATION