dBTechnologies INGENIA IG1T Manual Del Usuario página 48

CONNECTING THE POWER SUPPLY
POWER SUPPLY
ATTENTION!
Only use cables equipped with high-quality Neutrik® original connectors.
Replace any damaged cables, to avoid malfunctions and poor sound quality.
To properly install the INGENIA IG1T speaker:
• Properly connect the audio input (6), using the "INPUT SENSITIVITY" (7) selector to set the source. If
the input signal comes from a line or from a mixer output set the selector (7) to "LINE"; if the input
signal comes from a microphone (use a dynamic microphone), set the selector (7) to "MIC". For a brief
overview of audio cables, please refer to the table at page 48.
• Connect the power supply, connecting the cable equipped with Neutrik® powerCON TRUE1® connector
to "MAINS INPUT" (8).
• At switch-on the peak LED blinks briefly and the OLED screen (2) activates, displaying the initial level
and gain control screen:
• Turn the PUSH ROTARY ENCODER (3) to the left or to the right to adjust the system gain to an
appropriate level.
• Verify the correct sound emission of IG1T.
INGENIA IG1T
48
All manuals and user guides at all-guides.com
English
Cod. 420120237 REV. 1.1