Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment of Balance in Zeros.
1.
Check that the scale is situated in a steady surface. Go up and down on the scale several times so
that all parts are aligned.
2.
Without any weight on the scale, set both counterweights in their corresponding zero. The pointer
of the scale must move up and down freely, without touching the upper or the lower part of the
limitative rectangle.
3.
If the pointer of the scale does not move the same distance up and down with respect to the centre
of the limitative rectangle, move the equilibrating counterweights of the tiltable arm (picture 1)
until its correction.
4.
From this moment the NUOVA BISA scale is ready for use.
picture 1
Putting the height rod
1.
Insert the screws in the holes of the lower side of the height rod.
2.
Put the separating circular tubes inside the screws.
3.
Place the screws towards the two holes in the pillar of the scale and press with a screwdriver.
(picture 2)
4.
Verify that the height rod is straight.
picture 2
INSTALLATION
Counterweights
Level
Swinging head
Balancing weight
Column
Transmission rod
7
Publicidad
Tabla de contenido
