Publicidad
Idiomas disponibles
Idiomas disponibles
Change Grill Main Burner Valve Orifices
1.
Remove the grates and flame tamers.
2.
Remove the screw and pin that hold the burner in place.
Set the screw and pin aside.
3.
Remove the burner from the grill by lifting the burner out.
4.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the LP brass orifice from the end of the gas valve.
The main burner NG orifice is located behind the LP orifice,
so no additional orifice needs to be installed.
A. Main burner orifice
IMPORTANT: Check that the LP orifice is properly
removed inside of the burner opening.
5.
Reinsert the burner and reattach using the pin and screw
previously removed. Repeat the procedure for each main
burner.
6.
Position the igniters so they are 1/8" (3.2 mm) away from
each burner.
Change the Sear Burner Orifice
1.
Use a screwdriver to remove the screw from the ignitor
pin.
2.
Remove two screws on the rear of the searing burner. Lift
the burner starting from the back, as shown.
3.
Use a 6 mm socket wrench or 6 mm nut driver to remove
the orifice.
A
42
Publicidad
