Publicidad
Idiomas disponibles
Idiomas disponibles
Before You Begin
The SoundSpa Fusion uses a backup battery system to provide
continuous alarm and clock settings in the event of a power failure. Two
"AA" batteries (included) must be inserted into the battery compartment if
memory backup is desired. When the Backup Battery is installed, in the
event of a power failure or the DC cord is accidentally disconnected, the
LCD display will not remain lit, but the current time and alarm time settings
will be temporarily maintained.
Changing the Colored Faceplates
Attaching Faceplates
1. Choose a faceplate.
2. Slide top lip of faceplate under top lip of SoundSpa Fusion unit
(Fig. 5-A).
3. Press firmly on faceplate until it locks in place (Fig. 5-B).
Removing Faceplates
1. Use thumb to press latch on bottom of SoundSpa Fusion. Press firmly
so faceplate pops off unit (Fig. 6).
2. See ATTACHING FACEPLATE for directions on replacing the faceplate.
Getting Started
Setting Clock Time
1. Press the TIME SET BUTTON located on the top of the unit (Fig. 1);
hour digit will begin flashing. Turn the SET +/- KNOB until the current
hour is displayed. Remember to set the correct AM or PM (an icon in
the upper left of the time display is the PM INDICATOR; there is no AM
indicator) (Fig. 2).
2. Press the TIME SET BUTTON again; minute digits will begin flashing.
Turn the SET +/- KNOB until the current minute is displayed.
6
3. Press the TIME SET BUTTON again to exit the clock setting mode or
after 5 seconds the display will stop flashing to indicate the time is set.
Install/Replace Backup Battery
1. Make sure the DC adaptor is connected. Otherwise the time setting
may be lost during battery replacement.
2. Open the battery compartment cover located on the bottom of the unit.
3. Insert two AA batteries, checking that the positive polarity matches the
picture in the battery housing.
4. Close the compartment cover.
B B a a t t t t e e r r y y P P r r e e c c a a u u t t i i o o n n s s
1. Use only the size and type of batteries specified.
2. When installing batteries, observe proper +/ – polarities. Incorrect
installation of battery may cause damage to unit.
3. Do not mix different types of batteries together (e.g. alkaline with
carbon-zinc or old batteries with new ones).
4. If the unit is not going to be used for a long period of time, remove
batteries to prevent damage due to possible battery leakage.
5. Do not dispose of batteries in fire. Batteries may explode or leak.
Charging your iPod
The SoundSpa Fusion comes with four dock inserts. See chart below to
determine the size insert you should use.
Insert Label
iPod Model
3G nano
iPod nano 3rd Generation
4G nano
iPod nano 4th Generation
Classic
iPod Classic (80GB & 120GB), iPod Touch (8GB, 16 GB &
80G/Touch
2ND Gen.), 5G iPod with Video (30GB), U2 iPod with video
Classic 160G
iPod Classic (160 GB), 5G iPod with video (60GB, 80GB)
7
Publicidad
