Publicidad
Idiomas disponibles
Idiomas disponibles
Listening to a non-docking iPod or other
portable audio devices
If you are using an iPod without a
docking port, other MP3 player, or
other portable audio device, you can
play it through the SoundSpa Fusion
via the LINE IN located on the back
of the unit (Fig. 9).
1. Plug one end of the Connection
Cable (included) into the
headphone or line-out jack on your audio device and the other
end of the Connection Cable into the SoundSpa Fusion LINE
IN, located on the back of the unit.
2. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
3. Toggle through the AUDIO BUTTON on the unit until you reach the
auxiliary mode. The AUX ICON (Fig 2) will appear in the right side of the
clock, to indicate that the auxiliary mode has been selected.
4. Turn on and play external audio device.
5. Turn on VOLUME KNOB (Fig 1) on the unit to adjust the system volume.
Note: You may need to adjust the volume on external device also.
6. To turn off the unit, press the POWER BUTTON on the top of the unit.
Note: You may need to turn off your external audio device as well.
Listening to Nature Sounds
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Select the Sounds button to toggle through the different nature sounds
(Fig 1). They will be shown on the bottom of the LCD display, below the
time. (FIg. 2)
Figure 9
1 0
3. Turn the VOLUME KNOB on the unit to adjust the volume (Fig. 1).
4. To turn off the nature sounds, press the POWER BUTTON to turn the
unit off, or switch the audio mode by pressing the AUDIO BUTTON
(Fig. 1).
Note: When the unit is turned on, it
will always default to the
last mode used.
Listening to the Radio
FM Antenna
Extend FM wire antenna fully for best FM
reception (do not strip, alter or attach to
other antennas).
AM Antenna
Snap the AM loop antenna into the base provided. Next, plug the AM
loop antenna into the connecter located on the back of the unit for best
AM reception (Fig. 10).
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Toggle through the AUDIO BUTTON to play the radio
(Fig. 1).
The RADIO ICON will appear on the right side of the clock (Fig. 2).
3. To choose between FM or AM radio, press the AUDIO BUTTON
again. The FM or AM icon will show on the left side of the clock to
indicate the band that is selected (Fig. 2).
4. Turn the SET +/- knob on the unit to tune in the desired station
(Fig. 1).
5. Turn the VOLUME KNOB on the unit to adjust the system volume
(Fig. 1).
6. To turn off the unit, press the POWER BUTTON.
Figure 10
1 1
Publicidad
