Publicidad
Idiomas disponibles
Idiomas disponibles
B. The Using Attention
1. The outlet of the power supply must have the same voltage
as the local area.
2. Be sure the transmitter and the receiver were connected to
power supply.
3. In some situation, there are two or more equipment is
used within 100 feet at the same
equipment may not work well.
4. Please do not
use
another
frequency is similar to when the equipment is working .
5. To make the remote control face to the transmitter's IR
Remote control window, and the receiver's IR remote
control window (or extender accessory) to the source
equipment, the IR remote distance should be in the
Specifications range.
6. The LED of the receiver
remote control window would flash if receiving the remote
control signal when there is not harmful interference in
the ambient.
Caution: If the receiver's indication LED flash when the
transmitter is not operating. It indicates there is interference
in the ambient. Then perhaps, you can't control the system
so well.
time, perhaps the
one
which
operation
and
the transmitter's IR
3
C. Panel Controls and Features of Universal Type
The following illustrations show the names of each
component on the transmitter and receiver.
FRONT VIEW FOR TRANSMITTER AND RECEIVER
infrared passes through
this to remotely control
audio/video source
REAR VIEW FOR TRANSMITTER AND RECEIVER
DC power input, connect to
Power adapters (9VDC)
UHF antenna receivers
Remote control signal
Remote control window
IR extend
DC power input, connect to
Power adapters (9VDC)
UHF antenna sends
Remote control signal
4
Publicidad
