Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions for installation
•
Install the device in a position where it will not block the view of the driver.
•
Install the device within the wiping range if equipped the wiper.
•
Take care not to install the device over the vehicle inspection sticker or other sticker.
•
Take care not to install the device where it will interfere with driving or airbag operation.
•
If the device is installed incorrectly, event recording or parked recording may not work correctly.
•
Refer to "Installation and Connection" for the installation orientation, angle, and other
information and then install the device correctly.
•
Do not install the device near a digital terrestrial television antenna or an electrical component.
Otherwise it may reduce receiver sensitivity or cause flickering and noise.
When fixing the device with the adhesive mount, use a commercially available cleaning cloth or
•
the like to wipe off all dirt and grease on the mounting surface. If the device is re-affixed or
mounted using, for example, general-purpose double-sided tape, the adhesion strength may
weaken and cause the device to fall.
•
After mounting the device, leave it for 24 hours before use to enable the mounting strength of
the adhesive mount to improve. Failing to do so may result in the adhesion of the adhesive mount
becoming weak and the device falling.
•
Fix the cord in place with tape or the like so that it does not interfere with driving.
Precautions for use
•
Do not block the camera lens, get dirt on it, or place a reflective object near it.
•
When LED traffic lights are recorded, video in which they appear to be flickering or flashing may
be recorded. JVCKENWOOD assumes no responsibility with regard to the distinguishing or
recording of traffic lights.
•
If coating is used on the windshield of the vehicle, recording quality may be affected.
•
There is no guarantee that the device can record video in all conditions.
Cleaning the device
•
When the device is dirty, wipe it with a dry silicone cloth or other soft cloth. If the device is very
dirty, remove the dirt with a cloth with neutral cleaner on it then wipe off the cleaner. Wiping the
device with a hard cloth or using a volatile substance such as thinner or alcohol may cause
scratches, deformation, deterioration or other damage.
•
When the lens is dirty, gently wipe it with a soft cloth dampened with water. Rubbing the lens
strongly with a dry cloth may cause scratches.
If you notice a problem with the device, turn off the power of the device and then contact your
dealer or nearest JVCKENWOOD service center.
02
Publicidad
