GE ASQ28 Manual Del Propietario E Instrucciones De Instalación página 11

Window Installation Instructions
7 INSTALL THE CASE
IN THE WINDOW
Carefully slide the case into the window
A
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window sill. Mount the case
to the window sill using 6 type B screws.
Drill pilot holes, if necessary.
6 type B screws
Sill
Thread a type C bolt about 1/2 of the way
B
into the outer face of the shortest angle
of each V-support.
Type C bolt
Position the V-supports on the case
C
bottom so that they will be near the
outside wall. Attach a V-support to each
side of the bottom of the case using type
A screws, 4 on each side.
D
E
F
Type B
screw
V-support
11
7 INSTALL THE CASE
IN THE WINDOW
Use a wood block (obtained locally)
between the leveling bolts and the wall
if the wall is weak or if the weight of the
air conditioner falls between the studs
in the wall.
Adjust the leveling bolts against the
outside wall so that the case has a slight
tilt to the outside. Tighten nuts with an
adjustable wrench. Use a level; no more
than a 1/2 bubble will be the correct case
slant to the outside.
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom
corners with 4 type B screws.
Top mounting rail
Type B
screw
(cont.)
Type B
screw
Type B
screw