Publicidad
Idiomas disponibles
Idiomas disponibles
Insignia NS-F24TV 24" Flat Panel Television
5 Press
or
menu.
6 Press
or
7 Press
or
In AIR mode, the television receives antenna
signals. In CABLE mode the television
receives cable television programs. Select:
•
AIR—If using a VHF/UHF antenna.
•
CABLE—If using cable television. If you
have any questions about these settings,
contact your dealer.
8 Press
to select START.
9 Press
or
The television begins to search and memorize
all available programs. It may take a few minutes
to finish searching.
Note
The television first memorizes analog programs.
After all available analog programs have been
memorized, it begins to memorize DTV programs.
During analog program memorizing, you can
press MENU to stop the process. The television
then starts memorizing DTV programs. If you want
to stop DTV program memorizing, press MENU
again.
Skipping unwanted channels
After saving channels into memory, you can skip
unwanted channels so that only the channels
you want to watch are selected with the CH+/-
buttons.
To skip unwanted channels:
1 Go to the Preset menu.
2 Press
or
3 Press
or
4 Press
or
5 Press
or
6 Press
to select SKIP.
7 Press
or
The channel will be skipped when you
browse through channels using the CH+/-
buttons.
Tip
To restore a skipped channel, use the number
buttons to select the skipped channel, then repeat
the previous steps and set SKIP to OFF.
to enter the Auto Program sub
to select ANTENNA.
to select AIR or CABLE.
to start Auto Program.
to select CH SETUP.
to enter the CH SETUP menu.
to select CH NO.
to select a channel number.
to select ON.
www.insignia-products.com
Checking DTV signal strength
You can check the strength of your DTV signal
and determine whether you need to adjust your
antenna or digital cable input. The stronger the
signal strength, the less likely you are to
experience picture degradation.
To check DTV signal strength:
1 Go to the Preset menu.
2 Press
or
3 Press
or
The bottom line on the CH SETUP menu
shows the signal strength for the current DTV
channel.
Selecting channels
You can use one of three methods to select a
channel:
•
Use the number pad.
•
Use the CH+ and CH- buttons.
•
Use the previous channel
Using the number pad
To go to a specific channel number:
•
Press the number buttons (0-9) and the
dash (-) button, then wait for the television
to change channels, or press ENTER to
go immediately to that channel.
For example, if you want to select channel
8-3, press 8-3 on the remote control. (Make
sure that you press the buttons within three
seconds of each other, or the channel won't
be entered correctly.)
Note
In some situations, virtual channel numbers do not
correspond to physical frequencies.
Using the CH+ and CH- buttons
To browse through the channels:
•
Press:
•
CH+ to browse up the channels.
•
CH- to browse down the channels.
Using the previous channel button
To switch between two channels:
•
Press the previous channel
switch between the current channel and the
previous channel.
to select CH SETUP.
to enter the CH SETUP menu.
button.
button to
9
Publicidad
