Publicidad
Idiomas disponibles
Idiomas disponibles
List of Materials
Removing the packaging.
I
CAUTION
Remove carton carefully, Wear gloves to protect against sharp
edges.
Supplied Part
Hood assembly with blower and
LED lamps already installed
5x45 mm
10" round air transition
Parts not supplied
Tools/Materials required
• Level
• Drill
• 1¼" (3 cm) drill bit
• ⅛" (3 mm) drill bit
• Pencil
• Wire stripper or knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Flat-blade screwdriver
• Metal snips
• Phillips screwdriver
I
WARNING
Remove the protective film covering the product before putting
into operation.
Pieces
1
4
1
Parts needed
• Home power supply cable
• ½" (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
• 1 wall or roof cap
• Metal vent system
Optional Accesories
KIT
CFM Reduction Kit
10" to 8" Transition Kit
Kit No Blower External
Kit No Blower In Line
*There are no HVI certified ratings available for the 8" transition
Kit configuration, please check with local building codes in order
to verify compliance without HVI certification.
** CAUTION: When using this CFM reduction kit, the maximum
BTU use for this hood is 65 KBTU's.
*** CAUTION: When using this CFM reduction kit, the maximum
BTU use for this hood is 78 KBTU's.
Supplied Part
Side spacers
4x8 mm
Grease filters
Part #
PINSV628SS
PINTR628SS
PINTR634SS
ACC0185752**
ACC0185271*
Pieces
2
10
30", 36": 2
48": 3
PINSV134SS
PINTR146SS
ACC0185099***
ACC0179547
ACC0179549
5
Publicidad
