Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the battery pack (see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
The recommended ambient temperature
range for using tools and batteries is between
-5°C and 50°C.
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry, and the ambient
temperature should be between 0°C and
50°C.
♦
Connect the battery pack e to the high-speed
charger 8 (see fig. A).
♦
Plug the mains plug into the mains power socket.
The green charge indicator LED w lights up
briefly, then the red indicator LED q lights up.
The green charge indicator LED w indicates
♦
that the charging process is complete and the
battery pack e is ready for use.
CAUTION!
♦
If the red charge indicator LED q flashes, this
means that the battery pack e has overheated
and cannot be charged.
♦
If the red and green charge indicator LEDs q
w both flash, this means that the battery
pack e is defective.
♦
Push the battery pack e back into the appli-
ance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
■
8
│
GB │ IE
Inserting/removing the battery
pack
Inserting the battery pack
Click the battery pack e into the appliance.
♦
Removing the battery pack
♦
Press the release button 7 and remove the
battery pack e.
Checking the battery charge level
♦
To check the battery status, press the battery
charge level button 0.
The status/remaining charge is shown on the
battery display LED 9 as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Getting started
Switching on and off
Switching to continuous operation:
First, press the ON/OFF switch 1 to the right
♦
so that you can then press it forwards, as indi-
cated by the arrow of the ON/OFF switch 1.
Switching off continuous operation
Press the ON/OFF switch 1 to the rear and
♦
downwards and release it.
Setting the cutting depth
WARNING! RISK OF INJURY!
►
Always switch off the appliance and remove
the battery before carrying out any work on
the appliance.
Loosen the screw 3 to adjust the depth stop 4.
♦
Move the depth stop 4 to the desired position,
then retighten the screw 3. Before beginning
work, ensure that there is sufficient space below
the workpiece so that the cutting bit does not
accidentally make contact with the surface
beneath it.
PRSA 20-Li A1
Publicidad
