Publicidad
Idiomas disponibles
Idiomas disponibles
C. CALORIE FUNCTION.-
This function counts up or down in
steps of 10 calories, up to a maximum
of 9990 calories. Pressing the MODE
key for more than two seconds will
reset all of the values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small
CAL
flashing.
3. Press the SET keys to select the
calories.
4. Begin the exercise and the calorie
value will begin the countdown, when
it reaches zero it will beep for 4
seconds,
advising
selected
calorie
reached , the calorie value will then
start counting upward.
D. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig. 1, and remove one of the
batteries to deactivate the monitor,
then replace the battery and the cover
(A), Fig.1.
The
NOTE:
automatically reset whenever the old
batteries are replaced with new ones.
E.- TELEMETRIC PULSE RATE
The monitor is equipped to receive
signals
from
measurement system.
The system comprises of a receiver (D)
and a transmitter (chest band) Fig 3.
(CALORIE)
window
you
that
value
has
ODO
function
a
telemetric
See telemetric pulse rate instruction
book.
F. TIME FUNCTION.-
This function counts up or down in
steps of one minute, up to a maximum
of 99:00 minutes.
Pressing the MODE key for more than
two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
3. Press the SET keys to select the
time.
4. Begin the exercise and the time
the
value will begin the countdown, when
been
it reaches zero it will beep for 4
seconds,
selected time has elapsed, the time
value will then start counting upward.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
will
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
pulse
Problem: Display segments of a
function read-out are not visible or
error
7
advising
you
messages
for
that
the
a
particular
Publicidad
