EVVO CLIMA P9 Manual De Instrucciones página 68

ENGLISH
6. TROUBLESHOOTING
Problem Possible causes
The air There is no electricity.
conditioning
does not work.
The full-tank indicator will flash.
The room temperature is too low
or too high.
In cooling mode, the room
temperature is lower than the set
temperature; in heating mode,
the room temperature is higher
than the set temperature.
In dehumidification mode, the
room temperature is very low.
There is direct sunlight.
The cooling
Doors or windows are open; there
effect is not
are a lot of people; or in cooling
good.
mode, there are other sources of
heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
The device The air conditioning is not placed
makes a lot of on a flat surface.
noise.
Compressor There is frost.
does not work.
Protection against overheating
system is activated.
The remote There is too much distance
control does between the machine and the
not work. remote control.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead.
68
CLIMA P9 3 IN 1
Possible solutions
Turn it on after connecting it to a
socket with electricity.
Discharge the water inside.
It is recommended using the
appliance in at the temperature
of 7-35 ºC.
Change the set temperature.
The appliance is in a room with a
temperature below 17°C.
Pull the curtain.
Close doors and windows.
Clean or replace the filter.
Clear obstructions.
Put the air conditioning on a flat
and hard place (to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and
then restart the appliance.
Let the remote control get
close to the air conditioning,
and make sure that the remote
control directly faces to the
direction of the remote control
receiver.
Replace batteries.