Publicidad
Idiomas disponibles
Idiomas disponibles
Magazine
For 7/8", 1" and
1-1/4" (22 mm,
25 mm, 32 mm)
3
For 1-1/2" (38 mm)
For 1-3/4" (45 mm)
Plate
NOTE: Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly
closed without adjusting the nail holder correctly,
the nail holder may be damaged.
(3) Place the nail coil in the magazine.
Insert the first nail into the magazine opening.
Magazine opening
First nail
Nail
(4) Close the magazine cover.
(5) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3
Fit the nail heads in the guide slot.
Guide surface
Driving hole
First nail
2 3
Nail guide
2
Pawl
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
4 Pulling the nails to the right
After checking and making sure that the magazine
cover is closed, hook your fingers on the nail
Nail holder
1
2
Magazine
Guide slot
1
4
Feeder
— 13 —
guide and knob, turn the nail guide clockwise
while pressing the knob downward, and then
close the nail guide completely.
Knob
4
Nail guide
(6) Lock the knob completely.
The Nailer is now ready to operate.
<NV45AE(S)>
(1) Press the magazine stopper and open the magazine
cover.
Magazine cover
(2) Adjust the position of the nail holder according to the
nail length.
The nail will not feed smoothly if the nail holder is not
correctly adjusted.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Move the nail holder up and down to align the top
of the nail holder with a mark on the holder shaft
in accordance with the length of the nails being
used.
3 Turn the nail holder 90 degrees clockwise until
you hear "click".
For 1-1/4"
For 1-1/2" and 1-3/4"
Magazine cover
Nail holder
NOTE: Before loading nails in the magazine, adjust the
nail holder. If the magazine cover is forcibly
closed without adjusting the nail holder correctly,
the nail holder may be damaged.
English
4
Magazine cover
Magazine stopper
For 7/8" and 1"
Mark
Publicidad
