Publicidad
Idiomas disponibles
Idiomas disponibles
H3010REV0109 Lead:Digital Humidifier Manual 2L
MAINTENANCE
· Always unplug the unit before servicing it in any way.
· The water temperature of the water remaining in the unit after use may be high.
· Do not submerse the unit in water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the hole where the water vapor
comes out. Wash out the unit with fresh water, using the cleaning brush and a soft cloth
as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside with a soft cloth. Do not use soap or
detergents.
AIR FILTER
Gently wipe away debris from the filter with a soft cloth. This filter does not need to be replaced.
ULTRASONIC DISK
Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). White vinegar will help to prevent this build up.
Fig. 1
Fig. 2
· Fully dry the inside and outside of the unit before storing it.
· DO NOT leave water in the unit.
· Store in a cool dry place.
E-8
2/24/09
12:55 PM
Page 5
STORAGE
TROUBLESHOOTING GUIDE
PROBLEM
SOLUTION
Water vapor & humidity are not
Power Plug: Unplug and then try again.
produced.
Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is correctly
attached. Make sure spring on tank cap moves freely
when pushed.
Air blows but water vapor is not
Excessive Water: Remove a certain amount of water from
produced.
the tank.
The desired humidity is lower than the current
temperature: increase the desired humidity.
Detergent residue in the tank: Wash the tank out
and try again.
Humidity level is low.
The surface of the ultrasonic metal disk may be dirty:
Wipe it off with a dry soft cloth. Clean with white vinegar.
The water in the unit is too cold: Replace with cool, but
not cold water.
Warm humidity is not produced.
It may take 10-15 min. before warm humidity is created.
The mist may not feel warm to the touch.
Check to see if base of unit feels warm to the touch. If so
warm mist is being produced.
The humidity has a bad smell.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
White dust is forming on nearby
Hard water will deposit a certain amount of dust. Dust in
furniture.
the air settles because of the added humidity in the room.
Use distilled water if this becomes a nuisance.
My current humidity will not go
The unit will not display a humidity setting below 25%.
below 25%.
This means the current humidity in your room is at or
below 25%.
E-9
Publicidad
