Publicidad
Idiomas disponibles
Idiomas disponibles
MP 2000
ASSEMBLING
1. Holding the head, insert it in the inlet (fig.1).
Rotate the head in the same direction as fig.2
until a small sound can be heard. The head has
been placed in the inlet. Try to rock the head
slightly to ensure it is placed well.
2. Place the feed screw into the head, long end
first, by turning the feed screw slightly until it is
set into the motor housing (fig.3).
3. Place the cutting blade onto the feed screw
shaft with the blade facing the front as
illustrated (fig.4). If it is not fitted properly,
meat will not be ground.
4. Place the desired cutting plate next to the
cutting blade, fitting protrusions in the slots
(fig.5).
5. Support or press the centre of the cutting plate
with one finger then screw the fixing ring until
tight with another hand (fig.6). Do not over
tighten.
6. Place the hopper plate on the head and fix into
position. Locate the unit on a firm place. The air
passage at the bottom and the side of the
motor housing should be kept free and not
blocked.
MINCING MEAT
1. Cut all foods into pieces (Sinewless, boneless and fatless meat is recommended, approximate size:
20 mm x 20 mm x 60 mm) so that they fit easily into the hopper opening.
2. Plug in and switch to "ON" position.
3. Feed foods into the hopper plate. Use only the food pusher (fig.7).
4. After use switch the unit off and unplug it from the power supply.
REVERSE FUNCTION
1. In case of jamming switch the appliance off by switch to "R" position.
2. Feed screw will be rotating in the opposite direction, and the head will get empty.
3. If it doesn't work, switch the unit off and clean it.
HOW TO MAKE NOODLES
1. Assemble all parts except the blade as the above steps.
2. Start the grinder, put the paste (cut into small pieces) into the food tube (use the pusher to press
them when necessary) and the noodles will come out from the cutting disc.
15
Publicidad
